Friday, February 10, 2012

How to bleed power steering pump on Toyota?

The simple procedure is as follows :---


  1. Check fluid level
  2. Jack up front of vehicle and support it with stands
  3. With the engine stopped, turn the wheel slowly from lock to lock several times.
  4. Lower the vehicle.
  5. Start the engine and run at idle for a few minutes.
  6. With the engine idling, turn the wheel left or right to the full lock position and keep it there for 2 to 3 seconds, then turn the wheel to the opposite full lock position and keep it there for 2 to 3 seconds. Repeat several times.
  7. Stop the engine.
  8. Check for foaming or emulsification of the power steering fluid.
  9. If the system has to be bled twice specifically because of foaming or emulsification, check for fluid leaks in the system.

This will help.

See below latest solved car problems:-----

How to replace Tie Rod Ends on Chevy silverado 2500HD?


How to replace steering linkage on Chevrolet Silverado 2500 HD?


How to Replace power steering pump on Chevy silverado 2500 HD?


How to replace Power steering rack and pinion gear on Chevy Silverado 2500 HD?


Power Recirculating Ball Steering Gear removal on Chevy silverado 2500 HD?


Chevy Silverado 2500 HD steering wheel replacing Procedure?


Steering Wheel Locked?

How to replace Power Rack and Pinion Steering Gear on Acura Car Models?

How to replace Power Steering Pump on Acura Car Models?

Also bleeding:

How to replace Steering Linkage on Acura Car Models?

How to replace Steering Wheel on Acura Car Models?

How to replace Power Steering Pump on 1999 Acura TL?

How to Disarming the Air Bag System?

How to remove steering wheel on Chevrolet Malibu?

How to Remove Power steering Pressure Hose on Dodge Stratus

Car steering wheel makes noise?

Car makes clicking or tapping sound?

How to replace power steering pump on Mitsubishi Diamante?


No comments:

Post a Comment