The problem noticed on Volkswagen Golf model.
There should be bolts straight up holding the pan to the block, including INSIDE the transmission bellhousing area. After that, it may be just the pan gasket/oil separator hanging up on the oil pump pickup tube- it has cross baffles and when removing it may be "glued" to the pan by the time and heat- just take the time to fo around the perimeter and loosed the pan gasket from the pan, and remove the two things separately.
Its simple.
This will help.
Thanks.
See below latest solved problem :----
How to compare pattern of left bank and right bank sensors?
http://schematicsdiagram.blogspot.in/2012/02/how-to-compare-pattern-of-left-bank-and.html
Where is secondary air pump solenoids located?
http://repairhelpcenter.blogspot.in/2012/03/where-is-secondary-air-pump-solenoids.html
How to remove the sump on VW Beetle?
http://repairhelpcenter.blogspot.in/2012/03/how-to-remove-sump-on-vw-beetle.html
Check power train warning light on?
Check power-train message with orange engine light came on?
Check Powertrain message and Safety Mode Reduced Performance on Holden VZ Commodore?
http://howtobyme.blogspot.in/2012/02/check-powertrain-message-and-safety.html
Hyundai coupe f2 hazard fault?
http://schematicsdiagram.blogspot.com/2012/01/hyundai-coupe-f2-hazard-fault.html
Where is the pcv valve located on 2007 Duratec ford focus xr5?
http://repairhelpcenter.blogspot.in/2012/02/where-is-pcv-valve-located-on-2007.html
Bottoms Out while driving?
http://schematicsdiagram.blogspot.in/2012/02/bottoms-out-while-driving.html
Gas door hinges broken on
http://technoanswers.blogspot.in/2012/02/gas-door-hinges-broken-on-toyota.html
From where to buy new flow valve for Citroen 16 BX?
http://schematicsdiagram.blogspot.in/2012/02/from-where-to-buy-new-flow-valve-for.html
Where is the throttle position sensor located on the 1999 Cadillac DeVille?
http://schematicsdiagram.blogspot.in/2012/02/where-is-throttle-position-sensor.html
Where is the bulb located in glove box?
http://repairhelpcenter.blogspot.com/2012/01/where-is-bulb-located-in-glove-box.html
Additional wiring harness needs to be installed in a brake controller for electric brakes on 2012
http://repairhelpcenter.blogspot.com/2012/01/additional-wiring-harness-needs-to-be.html
How to deal with Engine Dieseling issues?
http://schematicsdiagram.blogspot.in/2012/03/how-to-deal-with-engine-dieseling.html
Engine keeps dieseling?
http://schematicsdiagram.blogspot.in/2012/03/engine-keeps-dieseling.html
Noise coming from the driver side under the air intake filter?
http://schematicsdiagram.blogspot.in/2012/02/noise-coming-from-driver-side-under-air.html
Fail smog test due to gas filter hose?
http://repairhelpcenter.blogspot.com/2012/01/fail-smog-test-due-to-gas-filter-hose.html
Clutch squeaking under hood?
http://repairhelpcenter.blogspot.com/2012/01/clutch-squeaking-under-hood.html
Clutch pedal drags and grabs while changing gears?
http://schematicsdiagram.blogspot.in/2012/03/clutch-pedal-drags-and-grabs-while.html
Clutch slipping problem?
http://howtobyme.blogspot.in/2012/03/clutch-slipping-problem.html
How to open Stuck up bonnet on Volvo s40?
http://schematicsdiagram.blogspot.in/2012/02/how-to-open-stuck-up-bonnet-on-volvo.html
WHERE IS THE PAINT CODE IDENTIFICATION NUMBER located on BUICK cars?
http://schematicsdiagram.blogspot.in/2012/02/where-is-paint-code-identification.html
How to remove Rear Adjustable Arm on 2007 Toyota Camry?
http://schematicsdiagram.blogspot.in/2012/02/how-to-remove-rear-adjustable-arm-on.html
There should be bolts straight up holding the pan to the block, including INSIDE the transmission bellhousing area. After that, it may be just the pan gasket/oil separator hanging up on the oil pump pickup tube- it has cross baffles and when removing it may be "glued" to the pan by the time and heat- just take the time to fo around the perimeter and loosed the pan gasket from the pan, and remove the two things separately.
Its simple.
This will help.
Thanks.
See below latest solved problem :----
No comments:
Post a Comment