How To Replace Engine Fan on Ford Expedition and Lincoln Navigator?

The procedure is similar for both ford and Lincoln car models:-----

The engine Fan replacing procedure is as follows:---

Removal & Installation:---

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the cooling fan electronic clutch electrical connector.
3. Remove the nut and the cooling fan electronic clutch harness support bracket from the stud bolt.
4. Release the cooling fan shroud position tab and rotate the shroud upwards until the lower tab locks into position.
5. Using the special tools 303-214 and 303-239, remove the cooling fan assembly.
6. To install, reverse the removal procedure and note the following:
   1. Tighten the cooling fan electronic clutch harness support bracket nut to 10 ft. lbs. (13 Nm).
   2. Tighten fan assembly to 41 ft. lbs. (55 Nm). 
      
      
      
      Fig. View of cooling fan and clutch assembly

These details will help.

Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html