The details are ford and Mercury vehicles.
Wheel Speed Sensor Rings (Toothed Rings)
REMOVAL & INSTALLATION
The front wheel speed sensor rings are integral to the front hub and bearing assemblies.
Wheel Speed Sensors
REMOVAL & INSTALLATION
Wheel Speed Sensor Rings (Toothed Rings)
REMOVAL & INSTALLATION
The front wheel speed sensor rings are integral to the front hub and bearing assemblies.
Wheel Speed Sensors
REMOVAL & INSTALLATION
Instructions are as follows :----
Front Wheel
Rear Wheel
All Wheel Drive
Front Wheel Drive Models
Car repair guide?
http://technoanswers.blogspot.in/2012/03/car-repair-guide.html
- With the vehicle in NEUTRAL, position it on a hoist.
- Disconnect the wheel speed sensor electrical connector.
- Remove the 2 scrivets and position aside the fender splash shield.
- Remove the wheel speed sensor harness pin-type retainer.
- Remove the 2 wheel speed sensor harness retainers.
- Remove the bolt and the wheel speed sensor.
To install:
- To install, reverse the removal procedure and tighten the speed sensor bolt to 71 inch lbs. (8 Nm).
All Wheel Drive
Specific to:
Ford Taurus 2008-2009
Mercury Sable 2008-2009
- With the vehicle in NEUTRAL, position it on a hoist.
- Disconnect the wheel speed sensor electrical connector.
- Remove the wheel speed sensor bolt.
- On the left side, release the wheel speed sensor harness spring clip and the 2 pin-type retainers from the rear control arm.
- Release the wheel speed sensor harness spring clip and the 2 pin-type retainers from the rear control arm.
- On the right side, release the 3 pin-type retainers and remove the wheel speed sensor.
To install:
- To install, reverse the removal procedure and tighten the speed sensor bolt to 71 inch lbs. (8 Nm).
Specific to:
Ford Taurus 2008-2009
Mercury Sable 2008-2009
- With the vehicle in NEUTRAL, position it on a hoist.
- Disconnect the wheel speed sensor electrical connector.
- Remove the 2 rivets and position aside the fender splash shield.
- Remove the wheel speed sensor harness pin-type retainer.
- Remove the 2 wheel speed sensor harness retainers.
- Remove the bolt and the wheel speed sensor.
To install:
- To install, reverse the removal procedure and tighten the speed sensor bolt to 71 inch lbs. (8 Nm).
This details will help.
Thanks.
FOR MORE HELP GO TO: ---
No comments:
Post a Comment