How to replace Speed Sensor on Dodge Ram

Rear Differential speed sensor replacing on 2004 Dodge Ram 1500 Hemi

The procedure is as follows:----

Its not very difficult,with basic tools required.

 First remove the nut that holds the parking brake cables to the speed sensor.
Then pull the cables off the sensor.
Now unplug it, and remove the bolt/stud that holds the sensor down into the differential.
Then grab the sensor with pliers and twist it. If you pull straight up or try to pry it out you can break it off in the housing. Pull it up while twisting it back and forth, along with some penetrating oil and you'll be fine.

Also view the help image shown below:----

Differential speed sensor dodge ram

How to replace Wheel Speed Sensors?

The details are ford and Mercury vehicles.


Wheel Speed Sensor Rings (Toothed Rings)
REMOVAL & INSTALLATION

The front wheel speed sensor rings are integral to the front hub and bearing assemblies.


Wheel Speed Sensors
REMOVAL & INSTALLATION

Instructions are as follows :----

Front Wheel

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the wheel speed sensor electrical connector.
3. Remove the 2 scrivets and position aside the fender splash shield.
4. Remove the wheel speed sensor harness pin-type retainer.
5. Remove the 2 wheel speed sensor harness retainers.
6. Remove the bolt and the wheel speed sensor.

To install:

1. To install, reverse the removal procedure and tighten the speed sensor bolt to 71 inch lbs. (8 Nm).

Rear Wheel
All Wheel Drive

Specific to:

Ford Taurus 2008-2009

Mercury Sable 2008-2009

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the wheel speed sensor electrical connector.
3. Remove the wheel speed sensor bolt.
4. On the left side, release the wheel speed sensor harness spring clip and the 2 pin-type retainers from the rear control arm.
5. Release the wheel speed sensor harness spring clip and the 2 pin-type retainers from the rear control arm.
6. On the right side, release the 3 pin-type retainers and remove the wheel speed sensor.

To install:

1. To install, reverse the removal procedure and tighten the speed sensor bolt to 71 inch lbs. (8 Nm).

Front Wheel Drive Models

Specific to:

Ford Taurus 2008-2009

Mercury Sable 2008-2009

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the wheel speed sensor electrical connector.
3. Remove the 2 rivets and position aside the fender splash shield.
4. Remove the wheel speed sensor harness pin-type retainer.
5. Remove the 2 wheel speed sensor harness retainers.
6. Remove the bolt and the wheel speed sensor.

To install:

1. To install, reverse the removal procedure and tighten the speed sensor bolt to 71 inch lbs. (8 Nm).

This details will help.

Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html