Friday, November 25, 2011

How to inspect Vehicles tie rod end Sleeves?

If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.

The details are as follows :----

An internally threaded sleeve located between the tie rod ends. The sleeve is rotated to set toe in/toe out.

There is a threaded adjusting sleeve that connects the inner and outer tie rods. It has a right hand thread on one end and a left hand thread on the other end. During an adjustment, when it is turned it acts like a turnbuckle. Turning it one way shortens the tie rod assembly. Turning it the other way lengthens it.
Adjusting sleeves resemble a piece of internally threaded pipe. They have a slot or separation that runs either their entire length or just part way. Adjusting sleeves also have two crimping or squeezing clamps located at each end to lock the toe adjustment.
Badly rusted, worn or damaged adjusting sleeves should be replaced.

This is how this sleeve looks:---

You can buy this part from Auto zone service center.
For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.


The car will not start?


Car will not crank?


Car has no spark?


How to troubleshoot car battery?


How to test starter solenoid?



How to test cars starter?


How to replace starter in car?


car will turn over but will not start?


Car wont start?


No comments:

Post a Comment