For Relearning.
Procedure to Relearn after disconnecting the battery.
Reconnect/Relearn Procedure details are as follows :----
When the battery is disconnected and connected, the illumination display needs to be calibrated. After the battery is connected, rotate the dimmer switch from the lowest dim position to the full bright, dome ON position.
This will help.
Thanks.
See below the latest solved car problems :----
How to replace Drive Shaft bearing on Toyota pick up?
Car suddenly died and won’t start?
Car is starting but not turning over?
Engine cranks but will not start?
Exclamation indicator light on ford freestar dash?
2004 ford freestar van idles rough?
How to remove Intake Manifold Tuning Valve?
Trunk release Problem on Toyota Camry?
CMFI details for GMC vehicles?
Mazda MPV cranks but will not start?
MAZDA MPV WILL CRANK BUT NOT TURN OVER TO START?
Freightliner fl112 fuse box diagram?
Car will not turn the ignition to start?
Ignition Key OFF but engine still running?
Dodge Dakota stalls, stumbles at idle. Has low fuel flow and runs hot?
Car only starts when gas pedal is pressed?
How to compare pattern of left bank and right bank sensors?
Ford Focus Component location?
Where is secondary air pump solenoids located?
Check power train warning light on?
Check power-train message with orange engine light came on?
Check Powertrain message and Safety Mode Reduced Performance on Holden VZ Commodore?
http://howtobyme.blogspot.in/2012/02/check-powertrain-message-and-safety.html
No comments:
Post a Comment