Oil Pan Replacing on Acura?

Oil Pan
REMOVAL & INSTALLATION: ---

1. Before servicing the vehicle, refer to the precautions section.
2. Drain the engine oil.
3. Remove or disconnect the following:
   
   
   Negative battery cable

   Front splash shield

   Heated Oxygen (HO ₂ S) sensor connector

   Exhaust front pipe

   Torque converter cover, if equipped with an automatic transaxle

   Oil pan

To install:

1. Install the oil pan. Apply liquid gasket as shown. 
   
   
   

   Fig. Apply liquid gasket to the inner threads of the bolt holes and the engine block along the area indicated by the broken line-MDX
2. Tighten the bolts in sequence to 105 inch lbs. (12 Nm) using several passes. 
   
   
   
   Fig. Oil pan tightening sequence-MDX
3. Wait at least 30 minutes before adding oil to the engine.
4. Install or connect the following:
   
   
   Torque converter cover, if removed

   Exhaust front pipe

   Subframe center beam, if removed

   HO ₂ S sensor connector

   Front splash shield

   Negative battery cable

This will help.
Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html