@

Monday, March 12, 2012

How to Replace Steering Wheel on Ford Windstar?

The details to replace Steering Wheel are as follows:---

Removal & Installation:--


CAUTION
The air bag system must be disarmed prior to service on or around any air bag component. The backup power supply must be disconnected to prevent accidental air bag deployment.

  1. Ensure the steering wheel and the vehicle-s front wheels are in the straight ahead position.
  2. Disconnect the negative battery cable.
  3. Pry out the two steering wheel spoke covers which cover the air bag module screws on the sides of the steering wheel. 

    image
    Fig. Air bag attaching screws are covered by plugs on each side of the steering wheel
  4. Remove the air bag module retaining screws on the side of the steering wheel from the driver side air bag module and lift the air bag module away from the steering wheel.

    Click image to see an enlarged view
    Fig. Remove the air bag attaching screw using the appropriately sized ratchet
  5. Label and disconnect the air bag wire harness, horn control wire and speed control harness.
    NOTE
    Ensure the air bag sliding contact assembly wire harnesses do not get caught on the steering wheel when lifting the wheel off of the steering shaft.
  6. Remove the steering wheel retaining bolt and discard.
  7. Install Steering Wheel Puller (T67L-3600-A) or equivalent, and remove the steering wheel.

    Click image to see an enlarged view
    Fig. Attach a steering wheel puller, then tighten the puller-s center bolt to press the wheel from the shaft
  8. Route the contact assembly wire harness through the steering wheel as the steering wheel is lifted off its shaft.
    NOTE
    Be sure the air bag sliding contact internal service lock is engaged. The air bag sliding contact should not be turned more than 45 degrees to the right or left to prevent damage.
  9. Rotate air bag sliding contact to the right or left to engage the service lock.
To install:
  1. Ensure that the steering wheel and the vehicle-s front wheels are in the straight ahead position.
    NOTE
    Be sure wiring does not get caught between steering wheel and air bag sliding contact or air bag monitor will detect a fault.
  2. Route the air bag sliding contact wire harness through the steering wheel opening at the three o-clock position. position steering wheel on steering shaft so the alignment marks are aligned. Be sure air bag contact wire is not pinched.
  3. Install a new steering wheel retaining bolt and tight to 25-34 ft. lbs. (34-46 Nm).
  4. Connect the air bag wire harness, horn control wire and speed control harness.
  5. Ensure all air bag to steering wheel seams are flush and no gaps are visible.
  6. Tighten air bag sliding contact retaining screws to 106 inch lbs. (12 Nm). Cover holes in the steering wheel with covers.
  7. Connect the negative battery cable and verify the air bag warning indicator is functioning properly.

This details will help.
Thanks.




No comments:

Post a Comment

@