@

@

Sunday, March 11, 2012

How to Replace Fuel Pump on 2007 Ford Taurus?


The instructions are similar for 2006 and 2007 ford Taurus Car models.

Fuel Pump
REMOVAL & INSTALLATION Details are as follows :----

  1. Before servicing the vehicle, refer to the precautions section.
  2. Properly relieve the fuel system pressure.
  3. Disconnect the negative battery cable.
  4. Using suitable hose pinching pliers, clamp the fuel tank filler hose in the location illustrated. 

    image
    Fig. Using suitable hose pinching pliers, clamp the fuel tank filler hose in the location illustrated
  5. Release the clamp to the fuel tank filler tube and remove. Disconnect the three quick release couplings from the fuel tank tubes.
  6. Disconnect the fuel pump electrical connector.
  7. Disconnect the fuel filter inlet tube.
  8. Position a suitable lifting device under the fuel tank.
  9. Remove the two fuel tank support strap bolts (one shown).
  10. Lower the fuel tank to access the fuel pump module while swinging the fuel tank support straps away from the fuel tank.
  11. Clean the area around the fuel pump mounting flange.
  12. Disconnect the fuel pump module electrical connector and the fuel pump module fuel outlet tube.
  13. Using the tool illustrated, remove the fuel pump module retaining ring. 
    CAUTION
    The fuel pump module must be handled carefully to avoid damage to the float arm, filter and convolute hoses.


    image
    Fig. Using the tool illustrated, remove the fuel pump module retaining ring
  14. Turn the fuel pump module counterclockwise and the fuel pump module will release from the locking tabs.
  15. Remove the fuel pump module from the fuel tank.
  16. Drain the fuel from the fuel tank.
To install:
  1. Installation is the reverse of removal.
  2. Tighten the fuel tank strap bolts to 26 ft. lbs. (35 Nm).
  3. Start the engine and check for leaks.

This will help.
Thanks.


FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html


Posted by Hemant somaiya at 1:21 PM
Labels: 2007 ford fuel pump removal, install fuel pump for taurus ford, replace fuel pump on 2006 ford taurus, replacing fuel pump, taurus fuel pump

6 comments:

  1. denwatsonDecember 6, 2013 at 2:53 AM

    Great learning for me, Thanks for share this post with us.Dow Corning DC 976 vacuum grease

    ReplyDelete
  2. Mueeid SoomroJanuary 27, 2017 at 2:48 AM

    A professional plumber can clear the pore and clean the sump. Every 2-3 months, test that the pump is operating correctly by pouring approx five gallons of tap water.
    this website

    ReplyDelete
  3. Jack sonFebruary 11, 2017 at 4:22 AM

    On the off chance that you need to get affirmation, going to the workplace of pipes contractual worker will be a way.
    http://www.alvarezplumbing.com/

    ReplyDelete
  4. Jason RichardsJuly 5, 2017 at 4:57 AM

    Plumbing services would include a lot of services such as water pipe fixations, kitchen pipes; sink outlets, toilet outlets, inlets, water heater fixing and repairing, overhead water storage tanks etc. Contractors Today

    ReplyDelete
  5. MatiasMay 23, 2018 at 8:43 AM

    I found so many interesting stuff in your blog especially its discussion. Really its great article. Keep it up. KP-LOK

    ReplyDelete
  6. Mona martinJuly 26, 2018 at 5:23 AM

    You have a genuine capacity for composing one of a kind substance. I like how you think and the way you speak to your perspectives in this article. I concur with your mindset. Much obliged to you for sharing. go now

    ReplyDelete

Subscribe to: Post Comments (Atom)

@

@