Front Wheel Bearings Replacing on Acura?

Wheel Bearings
ADJUSTMENT
REMOVAL & INSTALLATION: ----

The details are as follows :----

Adjustment

The wheel bearings are sealed units and are not adjustable.

Removal & Installation

1. Before servicing the vehicle, refer to the precautions section.
2. Remove or disconnect the following:
   
   
   Front wheel

   Brake hose mounting bolt

   Brake caliper

   Wheel speed sensor

   Spindle nut

   Brake rotor

   Outer tie rod end

   Lower ball joint

   Steering knuckle
3. Press the hub out of the wheel bearing.
   
   
   Splash guard

   Snapring and press the wheel bearing out of the steering knuckle
4. If necessary, press the inner bearing race off of the hub. 
   
   
   
   Fig. Press the wheel bearing out of the knuckle
   
   
   
   

   

   Fig. Press the wheel bearing inner race from the hub

To install:

Fig. Press the wheel bearing into the knuckle

Fig. Front wheel bearing assembly, spindle nut torque shown is for 2001-02, on 2003-06 torque is 210 ft. lbs. (285 Nm)

NOTE

Use a new ball joint nut, split pin, snapring and spindle nut for assembly.

1. Press the bearing into the steering knuckle and install the snapring.
2. Install the splash guard.
3. Press the hub into the bearing.
4. Install or connect the following:
   
   
   Steering knuckle. Tighten the ball joint nut to 43-51 ft. lbs. (59-69 Nm) and the damper flange bolts to 116 ft. lbs. (157 Nm).

   Outer tie rod end. Tighten the nut to 40 ft. lbs. (54 Nm).

   Wheel speed sensor, if equipped

   Brake caliper and rotor

   Brake hose

   Spindle nut. Tighten the nut to 181 ft. lbs. (245 Nm) on 2001-02 models. On 2003-06 models, torque to 210 ft. lbs. (285 Nm).

   Front wheel
5. Check the wheel alignment and adjust as necessary.

This details will help.

Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html