Acura Lower Control Arm Replacing?

Lower Control Arm
BUSHING REPLACEMENT
REMOVAL & INSTALLATION

The details are as follows :----

Bushing Replacement

The control arm bushings are serviced with the control arms as an assembly.

Removal & Installation

Lower Arm A

1. Before servicing the vehicle, refer to the precautions section.
2. Remove or disconnect the following:
   
   
   Lower arm mounting bolt and nut

   Lower arm
3. Installation is the reverse of removal. Tighten the bolt to 105 ft. lbs. (142 Nm) and the nut to 47 ft. lbs. (64 Nm). 
   
    
   
   Fig. Rear lower arm (A) mounting

Lower Arm B

1. Before servicing the vehicle, refer to the precautions section.
2. Support the control arm with a jack.
3. Remove or disconnect the following:
   
   
   Wheel

   Stabilizer link from the lower arm

   Wheel speed sensor wiring harness from the lower arm. Do not disconnect the connector.

   Flange bolts that attaches the lower arm to the knuckle
4. Spring assembly 
   
   
   Inner nuts and bolts and the arm 
    
   

   Fig. Rear lower arm (B) mounting
5. Install or connect the following:
   
   
   Arm, inner bolt and loosely install the nut

   Spring assembly
6. Raise the arm into position and install the flange bolt.
7. Raise the rear suspension with a floor jack to load the vehicle weight.
   
   
   Tighten the flange bolt to 54 ft. lbs. (74 Nm) and the inner nut and bolt to 61 ft. lbs. (83 Nm).

   Wheel speed sensor harness

   Wheel
8. Check the vehicle alignment.

This will help.

Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html