@

Monday, November 14, 2011

How to replace Antenna on Acura Integra?

Its not very hard,the procedure is as follows :---


Antenna


REPLACEMENT



Before beginning this procedure, check with your local parts supplier as to the availability of the antenna. This part may only be sold at your local Honda/Acura dealer.
  1. Remove the negative battery cable.
  2. Gain access to the antenna motor.
  3. Remove the trim panel.
  4. Detach the connector from the motor.
  5. Disconnect the antenna lead.
  6. Remove the antenna nut from the top of the fender.
  7. Remove the motor bracket nut.
  8. Remove the motor and antenna as an assembly.
  9. Remove the antenna nut spacer.
  10. Connect the wiring harness to the antenna assembly.
  11. Carefully pull out the antenna while an assistant turns on the radio.
To install:
  1. Carefully steer the teeth of the new antenna mast cable into the antenna housing.
  2. Check the engagement by gently moving the cable up and down a few times.
  3. Clean and lubricate the antenna mast housing threads with a light penetrating oil.
  4. Turn the radio switch off and let the power antenna's motor pull the cable down into the housing.
  5. Install the bushing, spacer, and the nut.
  6. The remaining steps are the reverse of the removal procedure.

-----------
For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------

No comments:

Post a Comment

@