Solved: wiper not working

Showing posts with label wiper not working. Show all posts

Sunday, February 26, 2012

1993 Ford F350 wipers not working?

Wipers not working.
It can be the issue with wiper motor or wiper switch or wiper control wiring.

Try this ,turn the wipers on and see if you hear any kind of roaring or humming noise. Basically this comes from behind the glove box. Its like a clicking noise.
Also as you turn the intermediate wiper switch you can hear the same noise at ech setting.Try this
Can you hear any such noise.

Above the right kick panel on your truck, where the noise is comming from is the wiper govenor<delay module> which basisally it is the timer for the delay wipers. even though you are hearing this click I have rarely seen these go bad but I have replaced alot of wiper motors. On your wiper motor does it have two plugs or one big plug? There was an updated motor that came out in the late 90's switching the 2 plug to the single. You can try tapping the motor with a ratchet or small hammer to see if it will free up the brushes and on the two plug motor there is a goung that comes out of it and hooks to one of the mounting bolts, make sure that ground is good. if you have a test light check it to make sure, even though it may look good you have steel and alloys mixing which after they corrode causing bad connections. If you have the five wire ,i will give more details.

Basically as per 1993 Ford F350 model.
The motor is with two plugs.
Three mounting bolts with no ground.

You can remove the wiper cowl and make sure that the wiper linkage is broke or bound up causing this.

I suggest you to go through this wiring diagram for wiper components.

This will help.
Thanks.

See below latest solved car problems :----

How to Replace a Windshield Wiper Motor

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-windshield-wiper-motor.html

Wipers not working, but hear relay click on Lincoln LS?

http://schematicsdiagram.blogspot.com/2011/12/wipers-not-workingbut-hear-relay-click.html

Saturday, January 14, 2012

Bmw 1 series rear wiper or washer not working?

In most cases its fuses or wiring issues.This is becoming an increasingly common problem on the 1-series so you are not alone.
The rear wiper has its own control unit mounted on the side of the motor behind the boot lid trim and this is the most likely cause of the problem. If you're sure that the fuse and wiring is ok then the rear wiper motor will more than likely require replacing. Unfortunately it isnt possible to check the switch without BMW equipment as it is optically switched.

See part number 8 shown in the diagram below:-------

This details will help.

Thanks.

Wednesday, November 16, 2011

Replacing Wiper Control module on 1999 Chevy Suburban?

Its not very hard.You can do this replacement.Wipers not working problem,many a times are due to faulty wiper circuit board or wiper control module.

All you have to do is replace the wiper module/circuit board. It's located under the hood, on the fire wall on the drivers side. You really can't miss it. Remove the 3 screws that hold the cover plate in place, remove the cover plate, unplug the old module and remove. Put in the new module, replace the cover plate and the 3 screws and plug it in. That's it...fixed. It really is that easy. The job took under 5 minutes to do.
You can get this module from your near by auto parts store.
This parts basically costs between $30 to $50.Depending on brand.Always buy car parts of branded quality,they are bit costly,but they lasts long.

This details will help.Thanks.

For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------