How to remove speakers on Acura Car models?

If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.

The procedure is as follows :---

Speakers

REMOVAL & INSTALLATION

See Figures 1 and 2

Fig. Fig. 1: Removing an Acura door mounted speaker

Fig. Fig. 2: Note how this old, dry rotted speaker has torn away from the foam rubber that keeps the paper cone suspended. At this point the only cure is to replace the entire speaker; if not sound quality will suffer

1. Disconnect the negative battery cable.
2. Remove any necessary paneling to gain access to the speaker.
3. Remove the protective mesh grill if applicable.
4. Unfasten the speaker mounting screws.
5. Pull the speaker partially up, then detach the electrical connector.

See Figure 3

Fig. Fig. 3: Detach the wiring harness from the rear of the speaker

6. Remove the speaker from the vehicle.

See Figure 4

Fig. Fig. 4: Remove the plastic baffle from the speaker

7. Installation is the reverse of the removal procedure.

-----------------

For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

http://schematicsdiagram.blogspot.com/2011/06/car-will-not-start.html

-----------------

Car will not crank?

http://schematicsdiagram.blogspot.com/2011/06/car-will-not-crank.html

-----------

Car has no spark?

http://schematicsdiagram.blogspot.com/2011/06/car-has-no-spark.html

-------------

How to troubleshoot car battery?

http://schematicsdiagram.blogspot.com/2011/06/how-to-troubleshoot-car-battery.html

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-starter-in-car.html

-----------

car will turn over but will not start?

http://technoanswers.blogspot.com/2011/05/car-will-turn-over-but-will-not-start.html

-----------------

Car wont start?

http://howtobyme.blogspot.com/2011/10/car-wont-start.html

----------

How to setup sound on PC computers and laptops?

If you have proper drivers for sound, its hardly a few minutes tie to set sound on your new or may be old pc.

Install the drivers for the sound device. If the sound hardware came with an installation disc, insert the CD into the drive and follow the prompts. If the sound device does not have a disc, contact the manufacturer or download the drivers from the manufacturer's website. To check the system for sound devices, go to "Start," "Control Panel" and "Sound and Audio Devices." The primary sound device will be shown in the top of this window. Step 2 Check the "Audio Devices" properties window for muted volume or the volume bar set to minimum. Either of these will cause the sound to not work. Step 3 Check "Device Manager" for improper settings or problems with the device. Go to "Start," "Control Panel" and "System," then select the "Hardware" tab, then press the "Device Manager" button. A list of hardware will be displayed. Audio devices are under "Sound Video and Game Controllers." The device will be titled the same as it appeared in the "Sound and Audio Devices" window in the "Control Panel." By double clicking on the device, it will display the properties. There is a selection at the bottom of the first tab that will display whether the device is "Enabled" or "Disabled." Any conflicts will also be given in the form of small exclamation marks. Step 4 Check the volume knob on the physical speakers. 
This details will help you.
Thanks.