How to Inspect Camshaft & Valve Lash Adjuster on Ford Escape and Mercury Mariner?

The procedure is similar for both Ford and Mercury car models:----

The details to inspect Camshaft & Valve Lash Adjuster is as follows:---

Inspection

Camshaft Inspection

Specific to:

Ford Escape 2008-2009

Mercury Mariner 2008-2009

1. Inspect camshaft lobes for pitting or damage in the contact area. Minor pitting is acceptable outside the contact area. 
   
   
   
   Fig. Camshaft lobe contact area inspection
2. Use the dial indicator gauge with holding fixture to measure camshaft intake/exhaust lobe lift.
3. Rotate the camshaft and subtract the lowest indicator reading from the highest dial indicator gauge reading to figure the camshaft lobe lift.
   
   NOTE

   Camshaft journals must be within specifications before checking runout.
   
   
   
   
   

   

   Fig. Measuring camshaft intake/exhaust lobe lift
4. Using the Dial Indicator Gauge with Holding Fixture, measure the camshaft runout.
5. Rotate the camshaft and subtract the lowest indicator reading from the highest dial Indicator gauge reading.
   
   
   

   

   Fig. Measuring the camshaft runout

Hydraulic Valve Lash Inspection

Specific to:

Ford Escape 2008-2009

Mercury Mariner 2008-2009

1. Inspect the hydraulic lash adjuster and roller follower for damage. If any damage is found, inspect the camshaft lobes and valves for damage.
   
   
   

   

   Fig. Hydraulic lash adjuster
   
   
   
   

   

   Fig. Roller follower

These details will help.

Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html

Valve Lash ADJUSTMENT For Acura?

Valve Lash
ADJUSTMENT: ---
The details are as follows :---

Adjustment

Adjust the valves only when the cylinder head temperature is less than 100°F (38°C).

1. Before servicing the vehicle, refer to the precautions section.
2. Remove or disconnect the following:
   
   
   Negative battery cable

   Air intake tube

   Intake manifold

   Valve cover
3. Rotate the crankshaft so that the valves to be adjusted are closed and the rocker arm is contacting the camshaft lobe base circle.
4. Measure the valve clearance. If adjustment is necessary, loosen the locknut and turn the adjusting screw as necessary to achieve the correct valve clearance.
5. The correct valve clearance is:
   
   
   Intake valves: 0.008-0.009 inches (0.20-0.24mm)

   Exhaust valves: 0.011-0.013 inches (0.28-0.32mm)
6. After adjustment, tighten the locknuts to 14 ft. lbs. (20 Nm).
   
   
   

   

   Fig. Inspect the valve clearance, adjust to specification and tighten the retainer to specification
   
   
   
   

   

   Fig. Valve adjusting retainer locations
7. Install or connect the following:
   
   
   Valve cover

   Intake manifold

   Air intake tube

   Negative battery cable
8. Start the engine and check for proper operation.

This will help.

Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html