Door Will Not Get Open From Inside
Most probably the inside door Handel holding assembly is got bit loose or the door Handel is broken and needs replacement.The door Handel assembly easily available at local auto part store or at dealer.
It costs approx $30 to $ 50.The rate depens on quality and store.
What's Inside The Door Panel Assembly
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them.
You'll need to lift the door panel upwards in order to get it off the window ledge.
If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door.
If the Door Is Not Getting Open and To Manually Open the Door From Inside
You need remove the cover that is behind the inside door handle and you will see the arm that connects to the handle.
Inspect this arm carefully, if its connected then you will have to remove the inner door panel,if its come off the handle and you get a hold of it you can pull on it and the door should open.
Please dont apply force,you have to be patient to remove the door panel with the door closed.
You will need to remove some screws to loosen the panel from the steel door inner panel.(arm rest,cover behind the handle).
Once this is done pop up the power door/window switch control and remove the plug attached.
Pull out the inner door panel to unhook the clips around the outside edge of the panel,you will have to move the seat to get better access to some,then remove the panel and reach into the inner door and move the unlock arm to open the door.
You may have clips that are broken that allowed the arms to come off that need replacing to fix the problem.
The clips are made up of plastic and easily available at Auto parts store.
ALSO view the condition of door handel,is the cable that holds the handel from inside got loose.
The inside handle is broken and not pulling the cable. When you replace it you will need either a commercial rivet gun and large rivets (like the factory used):
Or replace the rivets with a nut & bolt. If you use the nut & bolt I would use some blur Lock-Tite.
Basically there are two types of door handel used.
See the image shown below:
The first one is missing a piece of plastic on the handle right were the lock latch is.
If the door lock changes position while the door is closed, the interior door handle will open the door only once, and then the door will not latch nor will the handle operate the mechanism UNTIL you lock and unlock the door, which can take several times pressing lock and unlock until it unjams itself.
If the door latch is not completely unlocked, it won't latch when you close the door.
You can test this by holding the lock knob down a bit, and try closing the door.
The repair on such cases needs a new lock actuator, it will not unlock fully because the rubber boot is gone, and it corroded the solenoid.
This details will help.
Thanks.
ALSO VIEW THIS RELATED:
For Car parts and diagrams:
CAR MANUAL GUIDE
FOR FREE MANUALS AND GUIDES: ---
Car repair guide?
For all types of car repair help:
Car Backfires
For car repair How to guides:
|
|
OVERHEATING: Radiator Fan Not Working
Engine Cooling Fan not Working
"Radiator fan" "Engine Fan"
"COOLING FAN WILL NOT TURN OFF"
LIFT GATE / TAIL GATE ISSUES
TRUNK WILL NOT OPEN
CAR ALARM ISSUES
Car starter removal, Starter motor testing, Starter repairs, Starter
solenoid, Starter wiring,
DOOR PANEL REMOVAL, car door panel, door panel components, front
door panel, rear door panel,
HEATER CORE REPLACEMENT, HEATER CORE REMOVAL, TROUBLESHOOT HEATER CORE , FLUSH HEATER CORE ,
CAR POWER SEAT, ELECTRIC SEAT, POWER SEAT WILL
NOT WORK , SEAT WILL NOT GO FORWARD,
For all types
of---------
Timing belt
routing diagrams for cars and trucks?
==========
For all types of
--------
Drive belt
routing diagrams for cars and trucks?
stalling issues:
Engine stalls, car stalls while starting, vehicle stalls while
starting, Engine stalls and dies, Car stalls and stops,
CRUISE CONTROL Not working, cruise control replacing,
troubleshooting cruise control problems,
TRANSMISSION PROBLEMS:
NO REVERSE ON TRANSMISSION
GEAR SHIFT ISSUES
Transmission fluid leak, transmission gears slip,
TRANSMISSION REPLACING AND TROUBLESHOOTING, INSPECTING
TRANSMISSION COMPONENTS, TRANSMISSION FAILURES, OD WARNING LIGHT,
TRANSMISSION FLUID FILLING, WHERE TO FILL TRANSMISSION FLUID,
AUTOMATIC TRANSMISSION FLUID, NO TRANSMISSION DIPSTICK,
WINDSHIELD WIPERS, WINDSHIELD WIPERS NOT WORKING,WIPER MOTOR
MAKING NOISE,NO WIPERS,WIPER FLUID LEAKS,WIPER FUSE AND RELAY,
COOLANT LEAK ISSUES, COOLANT LEAK PROBLEMS, COOLANT SENSOR, LOW COOLANT ,
BRAKE LIGHTS NOT WORKING, REPAIRING BRAKE LIGHTS, NO BRAKE LIGHTS,
CHECK ENGINE LIGHT,ENGINE WARNING LIGHT FLASHING,ENGINE LIGHT ON
DASH,DASHBOARD WARNING LIGHT,ECM ERROR CODES,
DASHBOARD WARNING LIGHTS ARE ON, ENGINE LIGHT ON DASH,WARNING
LIGHTS STEADY ON DASH,RESET DASH BOARD WARNING INDICATOR,
KEYFOB PROGRAMMING, REPROGRAMMING CAR KEY, KEYLESS ENTRY
RESET,ANTITHEFT WILL NOT LET CAR TO START, ANTI THEFT ISSUES, KEYFOB NOT
WORKING, KEYLESS ENTRY QUIT WORKING,
IGNITION KEY WILL NOT RELEASE, IGNITION KEY STUCK UP, KEY WILL NOT
COME OUT OF IGNITION, FAULTY IGNITION KEY LOCK CYLINDER, REPLACING IGNITION
CYLINDER,
HEATER ISSUES:
HEATER NOT BLOWING COLD,NO HOT AIR FROM HEATER,A/C BLOWS HOT AIR,A/C
NOT BLOWING COLD, COLD AIR FROM HEATER,BLEND DOOR ACUTATOR CLOSED,HVAC UNIT NOT
OPERATING,
HEATER NOT BLOWING COLD,NO HOT AIR FROM HEATER,A/C BLOWS HOT
AIR,A/C NOT BLOWING COLD, COLD AIR FROM HEATER,BLEND DOOR ACUTATOR CLOSED,HVAC
UNIT NOT OPERATING,
STEERING ISSUES:
POWER STEERING TROUBLESHOOTING, STEERING SQUEAKS, POWER STEERING
FLUID LEAKS, FAULTY POWER STEERING PUMP, POWER STEERING NOT WORKING, POWER
STEERING BELT,
VEHICLE STARTING ISSUE:
CAR NO STAR T: ENGINE NOT TURNING
OVER:
No comments:
Post a Comment