@

Showing posts with label auto solutions. Show all posts
Showing posts with label auto solutions. Show all posts

Sunday, June 24, 2012

1999 – 2005 Chrysler & Dodge Guide?

Car Repair Guide covers all U.S. and Canadian models of the Chrysler/Dodge Avenger, Chrysler Sebring Coupe and Dodge Stratus/ Stratus Coupe models for Year 1999 to 2005.

At present this details are provided. Later on More details will be updated.

Its a free guide.

List of helpful procedures are provided.
Parts removal and installation details.Parts diagrams and many more help.


Control Cables Details and Replacing for Dodge and Chrysler?

 

Recirculation Door Cable Removal For Dodge and Chrysler?


Temperature Door Cable Removal For Dodge and Chrysler?

Blend Door Actuator Removal for Dodge & Chrysler?

Recirculation Door Actuator Replacing on Dodge And Chrysler?

How to Replace Blower Motor on Dodge & Chrysler?

How to Replace Compressor on Dodge & Chrysler?


How to replace Heater Core on Dodge and Chrysler?



The Heater core location and removing diagrams?

Junction block location-Diagram For Cirrus, Stratus, Sebring convertible and Breeze?


Heater/air conditioning housing assembly Diagram?

HVAC housing Diagram?

Heater core Location under HVAC housing?

How to Replace Control Panel on Dodge and Chrysler?


Control module Screws location Diagram?

Coolant Temperature Sensor Replacing on Dodge and Chrysler?

2.4L ECT Sensor Replacing on Dodge and Chrysler?
2.7L Coolant Sensor replacing on Chrysler and Dodge?

How to Test Coolant Sensor on Chrysler Sebring?

How to Replace ECT Sensor on Dodge Stratus and Chrysler Sebring?

How to Replace Engine Cooling Fans on Dodge and Chrysler?

How to Replace Radiator on Dodge Stratus and Chrysler Sebring?

How to Replace Thermostat on Dodge and Chrysler?

How to Replace Water Pump on Stratus, Avenger and Sebring?


3.0L Drive belt removal for Dodge and Chrysler?
Drive belt inspection and routing diagrams for 3.0L Dodge/ Chrysler?

Serpentine belt removal for 2.7L Dodge stratus and Chrysler Sebring?

Dodge Avenger Drive belt replacing?

2.0L, 2.4L and 2.5L Drive belt replacing on Stratus, Avenger and Sebring?
Drive belt routing diagram for Dodge and Chrysler?

2.0L Cylinder Head Replacing on Dodge Stratus?

2.0L Cylinder Head Replacing on Chrysler Sebring?

http://fordrepairhelp.blogspot.in/2012/04/cylinder-head-replacing-on-dodge.html

2.0L Cylinder Head Replacing on Dodge Avenger?

http://fordrepairhelp.blogspot.in/2012/04/cylinder-head-replacing-on-dodge.html


How to replace 2.5L Engine Cylinder head ON Avenger, Stratus and Sebring?


Dodge And Chrysler 2.7L Engines Cylinder Head Removal?


2.7L Stratus, Sebring and Avenger Cylinder head replacing?

Replace Cylinder head on 3.0L Engine?


Dodge Stratus Avenger and Chrysler Sebring 3.0L Cylinder head Replacing?

Replace 2.7L Engine on Dodge stratus, Avenger And Chrysler Sebring?
Replace 2.4L Engine on Dodge stratus, Avenger And Chrysler Sebring?

Replace 2.5L Engine on Dodge stratus, Avenger And Chrysler Sebring?

Replace 2.0L Engine on Dodge stratus, Avenger And Chrysler Sebring?

Exhaust Manifold Replacing on Dodge and Chrysler?

2.0L Exhaust manifold removal on Stratus, Avenger and Sebring?
Dodge and Chrysler 2.4L Engine Exhaust manifold removal?
Stratus, Avenger and Sebring 2.5L Exhaust manifold replacing?

2.5L Engine Exhaust Manifold Replacing on Dodge and Chrysler?

Chrysler and Dodge 2.5L Front Bank Exhaust Manifold Replacing?

 

Front Bank Exhaust Manifold Replacing on Stratus, Avenger & Sebring?

http://fordrepairhelp.blogspot.in/2012/04/front-bank-exhaust-manifold-replacing.html

Rear Bank Exhaust Manifold removal on stratus, Avenger & Sebring ?

http://fordrepairhelp.blogspot.in/2012/04/how-to-replace-rear-bank-exhaust.html

Rear bank Exhaust manifold replacing on Dodge and Chrysler

2.7L and 3.0L Exhaust Manifold Removal on Dodge and Chrysler?


3.0L Intake manifold replacing on Avenger, Stratus and Sebring?

http://fordrepairhelp.blogspot.in/2012/04/intake-manifold-replacing-on-avenger.html

2.7L Intake manifold replacing on Avenger, Stratus and Sebring?

http://fordrepairhelp.blogspot.in/2012/04/intake-manifold-replacing-on-avenger.html

2.5L Intake Manifold replacing on Avenger, Stratus and Sebring?

http://fordrepairhelp.blogspot.in/2012/04/25l-intake-manifold-replacing.html

Dodge and Chrysler 2.5L Intake Manifold replacing?

Dodge Stratus, Avenger and Chrysler Sebring 2.0L Intake manifold Replacing Procedure?

2.4L Timing Belt Replacing on Dodge and Chrysler?


2.4L VIN X Engine Timing belt Removal on Dodge and Chrysler?


Stratus, Avenger and Sebring Timing belt Replacing on 2.5L VIN H Engine?


Dodge and Chrysler VIN N Engine TIMING BELT Removal?


2.5L Vin N Timing belt Removal?

Dodge Stratus Timing Belt Replace and Install On VIN J & VIN F?


3.2L and 3.5L Engine Timing belt Replacing for Chrysler?

Avenger and Sebring Vin j and Vin f Timing belt removal?

3.0L Timing belt Removal on Chrysler and Dodge?


Timing Belt Front Cover Replacing on Stratus, Avenger and Sebring?


Procedure To Replace Timing Belt Rear Cover On Dodge and Chrysler?

How To Replace Timing Chain on Stratus, Sebring & Avenger?


Timing Chain Cover & Seal Replacing on Dodge Stratus, Avenger and Chrysler Sebring?

How to replace 2.5L Engines Cylinder Head Cover?


Spark Plug Tube Seals Replacing on Dodge and Chrysler?



Monday, November 21, 2011

How to replace Radiator on Audi and VW car models?


If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.



The procedure is as follows :----


Radiator


REMOVAL & INSTALLATION

CAUTION
NEVER open, service or drain the radiator or cooling system when hot; serious burns can occur from the steam and hot coolant. Also, when draining engine coolant, keep in mind that cats and dogs are attracted to ethylene glycol antifreeze and could drink any that is left in an uncovered container or in puddles on the ground. This will prove fatal in sufficient quantities. Always drain coolant into a sealable container. Coolant should be reused unless it is contaminated or is several years old.

  1. Disconnect the negative battery cable.
  2. Allow the engine to cool below 100°F (38°C).
  3. Drain the coolant into a suitable container. For additional information, please refer to the following topic(s): General Information and Maintenance, Fluids and Lubricants.
  4. On A4 & 1998-00 Passat models, remove the front bumper assembly. For additional information, please refer to the following topic(s): Body and Trim, Front Bumper.
  5. Remove the radiator hoses from the radiator.
  6. Disconnect the electrical connectors for the thermal fan switch and the electric cooling fan.
  7. On models equipped with automatic transmission, if equipped, place a suitable drain pan under the fluid lines, then disconnected and plug the transmission cooling lines.
  8. On 1990-97 Passat models:
    1. Remove the radiator mounting fasteners.
    2. Remove the upper radiator support/hood lock carrier. Outline the mounting fasteners for proper assembly.
    3. Carefully lift out the radiator complete with the fan assembly.
  9. On A4 & 1998-00 Passat models:
    1. Remove the mounting fasteners for the power steering cooling lines and move aside without disconnecting.
    2. If equipped with air conditioning:
    3. Remove the left and right side air guides.
    4. Remove the A/C condenser retaining clamp fasteners and retaining clamp.
    5. Disconnect the A/C pressure switch just beneath the headlamp.
    6. Place a suitable protective cover over the right fender, then move the condenser upward away from the retaining bracket and pivot to the side and support it at the right front wheel area using a sturdy wire loop or its equivalent. Do NOT disconnect the A/C lines from the condenser and avoid severe bending and kinking.
    7. Release the upper radiator retaining bolts, pulling up and removing.
    8. Tilt the radiator forward, lifting up to remove.


Click image to see an enlarged view
Fig. On A4 & 1998-00 Passat models, the upper radiator fasteners are removed by releasing the retaining bolts, then pulling up to remove
To install :
  1. Installation is in reverse order of removal noting the following points:
  2. Fill and bleed the cooling system with the recommended fluid and mixture ratio. The recommended engine coolant should only be diluted with distilled water. 

----------
This details will help.
Thanks.
-------------
For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------


Saturday, November 19, 2011

Coolant Level Sensor on Audi A4?


If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.


The details are as follows :----

Coolant Level Sensor


The coolant level sensor, located in the coolant reservoir, sends a signal to the indicator light in the instrument cluster to warn the driver of a low coolant level.
Testing
If the level of the coolant in the reservoir is full, and the indicator light in the instrument cluster is illuminated, proceed as follows:
  1. With the key in the ON position, unplug the harness connector from the coolant reservoir.
  2. Using a suitable jumper wire, connect the two terminals together.
  3. With the key in the ON position, and the terminals bridged, the light in the instrument cluster should extinguish.
  4. If the light extinguishes, replace the coolant level sensor.
  5. If the light continues to illuminate, check the wiring circuit for broken terminals, blown fuses, cut wires, etc. 

---------------

this will help.Thanks.
-----------

For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------

@